I am using the latest released from Denx's git repository v2018.05. I have built the cross toolchain and am now trying to build Das U-boot with that tool chain and the build fails due to THUMB instructions not being supported (by the compiler? by the BeagleBone?). I am trying to build u-boot for beagle bone black following instructions in "Mastering Embedded Linux Programming" by Chris Simmonds.
U boot for beaglebone black install#
When trying to specify a version, it fails as sudo apt-get install python3=3.4Į: Version '3.4' for 'python3' was not found Install these packages without verification ? yĮrr wheezy/updates/main python3.2-minimal armhf 3.2.3-7+deb7u1Įrr wheezy/updates/main python3.2 armhf 3.2.3-7+deb7u1Įrr wheezy/main python3-minimal all 3.2.3-6įailed to fetch 404 Not Found Į: Unable to fetch some archives, maybe run apt-get update or try with -fix-missing? Python3.2-minimal python3.2 python3-minimal python3 WARNING: The following packages cannot be authenticated! The following NEW packages will be installed:Ġ upgraded, 4 newly installed, 0 to remove and 240 not upgraded.Īfter this operation, 13.4 MB of additional disk space will be used. To install this bootloader, copy the files MLO and bb-uboot.img to the FAT partition on an SD card or the.
The following extra packages will be installed: U-Boot loader for BeagleBone and BeagleBone Black. it seems to try to install version 3.2 which does not exist on the download site (see sudo apt-get install python3 -V However, trying to install python3 with apt-get fails. The BeagleBoneBlack revC comes with Python2 installed. RNDIS Waiting for PHY auto negotiation to complete. Warning: usb_ether MAC addresses don't match:
Retrieving file: Waiting for PHY auto negotiation to complete. Using musb-hdrc, OUT ep1out IN ep1in STATUS ep2in Net: eth0: usb_ether MAC addresses don't match:Īddress in environment is d0:5f:b8:d1:0b:69īus Port not Waiting for PHY auto negotiation to complete. *** Warning - bad CRC, using default environment WDT: Started with servicing (60s timeout) I used u-boot v2020.07, crosstool-ng v1.24.0 and copied MLO, u-boot.img to sd card.
0 kommentar(er)
